Reshaping piano hammers

Okay folks it’s time will be able to write a write-up concerning piano hammers and the way they customize the tone of your piano. Way during the 1800s piano hammers were made with rabbit hair and alpaca hair and numerous various things. The results were much softer hammer it had not been nearly so harsh.

In our newer piano hammers they may be exclusively built and engrossed in pressed wool. When piano hammers created using wool get older, they generally tend for being hard and very brash, which requires these phones be needled and re- voiced to be able to bring the mellow tone to the piano.

In grand and vertical pianos, after heavy playing for several years the piano hammers get damaged from the hardness as well as the sounds become very harsh. More serious over the years piano hammers will also get  grooves within the crown with the hammer. These grooves get caught involving the strings and begin to mute a few of the tone.

Not just would be the sounds harsh but uneven  as well. Should you open the lid for your piano, and look lower you can observe the grooves inside the piano hammers. The grooves from playing the piano that show up, should not be allowed to become deep.Experience piano technicians understand how to reshape, lessen and re-voice a hammer which includes deep grooves inside. This won’t be made by somebody who has not been taught to reshape piano hammers.

The procedure that follows will explain how reshaping hammers  is done. Starting on top of the hammer about the hammers shoulder, filing in the downward motion you adopt off layers of felt until there aren’t any longer any deep grooves remaining. The contour with the hammer should stay as soon as the felt is taken off since it was ahead of your beginning. While filing the hammer it should be noted that one attention needs to be given to filing the hammer evenly so that it will strike all the strings in the note after completed. I have seen a lot of people try and reshape hammers more often than once. That is not recommended while there is not usually enough felt left for the hammer to achieve this procedure more than once. At that point in the piano’s life, it is better to entirely replace the piano hammers.

 

Leave a Reply